118 Configuring Security using the CLIFigure 21Security, Insert AuthConfig dialog box4 Complete the fields as required and click Insert.The new entry appears in theAuthConfig tab—End—Security, Insert AuthConfig dialog box fieldsTable 55 "Security, Insert AuthConfig dialog box fields" (page 118) describesthe Security, Insert AuthConfig dialog box fields.Table 55Security, Insert AuthConfig dialog box fieldsField DescriptionBrdIndx Index of the board. This corresponds to the index ofthe unit that contains the board, but only if the index isgreater than zero. A zero index is a wild card.PortIndx Index of the port on the board. This corresponds to theindex of the last manageable port on the board, butonly if the index is greater than zero. A zero index isa wild card.MACIndx An index of MAC addresses that are either designatedas allowed (station) or not-allowed (station).AccessCtrlType Displays whether the node entry isnode allowed or nodeblocked. A MAC address can be allowed on multipleports.SecureList The index of the security list. This value is meaningfulonly if BrdIndx and PortIndx values are set to zero. Forother board and port index values, this index must alsohave the value of zero.The corresponding MAC Address of this entry is allowedor blocked on all ports of this port list.Nortel Ethernet Routing Switch 2500 SeriesSecurity — Configuration and ManagementNN47215-505 (323165-B) 02.01 Standard4.1 19 November 2007Copyright © 2007, Nortel Networks.
