Securing your system 43Table 6no ipmgr command for source IP addresses parameters and variablesParameters andvariablesDescriptionsource-ip [<1-10>] When you specify an option, this command setsthe IP address and mask for the specified entry to255.255.255.255 and 255.255.255.255.When you omit the optional parameter, the list isreset to the factory defaults.Changing the http port numberThis feature provides enhanced security and network access. The defaultHTTP port typically used to communicate between the Web client and theserver is the well-known port 80. With this feature, you can change theHTTP port.You can configure this feature by using the following commands:• "show http-port command" (page 43)• "http-port command" (page 44)• "default http-port" (page 44)show http-port commandThe show http-port command displays the port number of the HTTPport. The syntax for the show http-port command is:show http-portThe show http-port command is executed in the Privileged EXECcommand mode.The show http-port command has no parameters or variables.Figure 3 "show http-port command output" (page 43) displays sample outputfrom the show http-port command command.Figure 3show http-port command outputNortel Ethernet Routing Switch 2500 SeriesSecurity — Configuration and ManagementNN47215-505 (323165-B) 02.01 Standard4.1 19 November 2007Copyright © 2007, Nortel Networks.
