92 Configuring Security using the CLIParameters andvariables DescriptionATTENTIONIf you omit this parameter, the system uses theport number that you specified when you issuedthe interface command.init Reinitiates EAP authentication.statusauthorized|unauthorized|autoSpecifies the EAP status of the port:• authorized— Port is always authorized.• unauthorized— Port is always unauthorized.• auto— Port authorization status depends on theresult of the EAP authentication.traffic-controlin-outIinSets the level of traffic control:• in-out— If EAP authentication fails, bothingressing and egressing traffic are blocked.• in— If EAP authentication fails, only ingressingtraffic is blocked.re-authenticationenable|disableEnables or disables reauthentication.re-authentication-period<1-604800>Enter the number of seconds that you want betweenre-authentication attempts.Use either this variable or the reauthentication-intervalvariable; do not use both variables because theycontrol the same setting.re-authenticate Specifies an immediate reauthentication.quiet-intervalEnter the number of seconds that you want betweenan authentication failure and the start of a newauthentication attempt; the range is 1 to 65535.transmit-intervalSpecifies a waiting period for response from supplicantfor EAP Request/Identity packets. Enter the number ofseconds that you want to wait; the range is 1-65535.Nortel Ethernet Routing Switch 2500 SeriesSecurity — Configuration and ManagementNN47215-505 (323165-B) 02.01 Standard4.1 19 November 2007Copyright © 2007, Nortel Networks.
