Securing your system 55default ssh [dsa-auth|pass-auth|port|timeout]The default ssh command is executed in the Global Configurationcommand mode.Table 13 "default ssh command parameters and variables" (page55) describes the parameters and variables for the default sshcommand.Table 13default ssh command parameters and variablesParameters andvariablesDescriptiondsa-auth Resets dsa-auth to the default value. Default isTrue.pass-auth Resets pass-auth to the default value. Default isTrue.port Resets the port number for SSH connections to thedefault. Default is 22.timeout Resets the timeout value for session authenticationto the default. Default is 60.Setting server for Web-based managementYou can enable or disable the Web server to use for the Web-basedmanagement system. This section discusses the following commands:• "web-server" (page 55)• "no web-server" (page 56)web-serverThe web-server command enables or disables the Web server thatyou use for Web-based management. The syntax for the web-servercommand is:web-server {enable|disable}The web-server command is executed in the Global Configurationcommand mode.Table 14 "web-server command parameters and variables" (page56) describes the parameters and variables for the web-server command.Nortel Ethernet Routing Switch 2500 SeriesSecurity — Configuration and ManagementNN47215-505 (323165-B) 02.01 Standard4.1 19 November 2007Copyright © 2007, Nortel Networks.