Chapter 4 Settings — [NETWORK] menuENGLISH - 1032) Press the button.f The [PROJECTOR NAME] screen is displayed.3) Select characters with the asqw buttons and press the button to enter the projectorname.f Up to eight characters can be input.f Select [ALL DELETE] to delete all the entered characters, or press the button on the remotecontrol to delete a character on the cursor in the entry field.4) Select [OK] with the as buttons and press the button.f To cancel the change of the name, press asqw to select [CANCEL] and press the button.Notef [Name ] ( is 4-digit number) is set before the projector leaves the factory.[NETWORK CONTROL]Set up the control method of the network.1) Press as to select [NETWORK CONTROL].2) Press the button.f The [NETWORK CONTROL] screen is displayed.3) Press as to select an item, and press qw to change the setting.[WEB CONTROL] Set to [ON] to control with the web browser.[PJLink CONTROL] Set to [ON] to control with the PJLink protocol.[COMMAND CONTROL] Set to [ON] to control with the terminal control command format (x page 145). Referto “Control commands via LAN” (x page 142).[COMMAND PORT] Set the port number used for command control.[Crestron Connected(TM)] Set to [ON] to control with Crestron Connected TM of Crestron Electronics, Inc.[AMX D.D.]Set to [ON] to control with the controller of AMX Corporation.Setting this function to [ON] enables detection through “AMX Device Discovery”. For details, refer tothe website of AMX Corporation.URL http://www.amx.com/[EXTRON XTP]Set to [ON] when connecting the “XTP transmitter” of Extron Electronics to the terminal.The [EXTRON XTP] setting must be set to [OFF] when connecting the optional DIGITAL LINK outputsupported device (Model No.: ET-YFB100G, ET-YFB200G).For details of the “XTP transmitter”, refer to the website of Extron Electronics.URL http://www.extron.com/4) Press as to select [OK], and press the button.f The current network control settings is saved.[NETWROK STATUS]Display the status of the projector network.1) Press as to select [NETWORK STATUS].2) Press the button.f The [NETWORK STATUS] screen is displayed.f The display screen (1/2 [WIRED LAN] → 2/2 [WIRELESS LAN]/[Presenter Light]) will change each time youpress as.[WIRED LAN][DHCP] Displays the usage state of the DHCP server.[IP ADDRESS] Displays the IP address.[SUBNET MASK] Displays the subnet mask.[DEFAULT GATEWAY] Displays the default gateway.[DNS1] Displays the address of the preferred DNS server.[DNS2] Displays the address of the alternate DNS server.[MAC ADDRESS] Displays the MAC address.[WIRELESS LAN] [SSID] *1 Displays the character string of SSID.[IP ADDRESS]*1 Displays the IP address.
