Panasonic PT-FZ570 Operating Instructions Manual

Also see for PT-FW530: Operating instructions (functional manual)Operating instructions

Contents

Panasonic PT-FZ570 Operating Instructions Manual Manual pdf 90 page image

Chapter 4 Settings — [PROJECTOR SETUP] menu90 - ENGLISH[ECO] Select this item to reduce power consumption during standby.Notef If [STANDBY MODE] is set to [ECO], you cannot use network functions when the projector is standing by. Also, you cannot use some RS-232C protocol commands.f When set to [ECO], it may take approx. 10 seconds longer before the projector starts projecting after the power is turned on, compared withwhen [NORMAL] is set.f When set to [NORMAL], it may take approx. 1 minute to enable the network function after connecting the power cord.f The setting of [STANDBY MODE] cannot be returned to the factory default even if the [PROJECTOR SETUP] menu → [INITIALIZE ALL] isexecuted. (Æ page 97)[RS-232C]Set the communication conditions of the terminal.Setting the communication condition of the terminal1) Press as to select [RS-232C].2) Press the button.f The [RS-232C] screen is displayed.3) Press as to select [INPUT SELECT].4) Press qw to switch the item.[PROJECTOR] Use the terminal of the projector to perform RS-232C communication.[DIGITAL LINK] Performs RS-232C communication via the DIGITAL LINK output supported device (Model No.:ET-YFB100G, ET-YFB200G) and the terminal.5) Press as to select [BAUDRATE].6) Press qw to switch the item.f The items will switch each time you press the button.[9600]Select the proper speed.[19200][38400]7) Press as to select [PARITY].8) Press qw to switch the item.f The items will switch each time you press the button.[NONE]Select the parity condition.[EVEN][ODD]Setting the control commands of an existing projectorWhen controlling the projector on a computer, set use of control commands on a previously purchased Panasonicprojector. This allows the control software for an existing Panasonic projector to be inherited and used.1) Press as to select [RS-232C].2) Press the button.f The [RS-232C] screen is displayed.3) Press as to select [EMULATE].4) Press the button.f The [EMULATE] screen is displayed.5) Press as to select an item.