Chapter 4 Settings — [POSITION] menu72 - ENGLISHf Press the button on the remote control when the [KEYSTONE], [CORNER CORRECTION] or [CURVED CORRECTION]screen is displaying, it will switch to the next adjustment screen.f When the [CORNER CORRECTION] individual adjustment screen is displaying, the individual adjustment screen of the next corner can alsobe displayed by pressing the button.f Correcting up to ±35° for the tilt in the vertical direction and ±35° for the tilt in the horizontal direction are available for adjustments with[KEYSTONE]. However, the image quality will degrade and it will get harder to focus with more correction. Install the projector so that thecorrection will be as small as possible.f Screen size will also change when [KEYSTONE] is used to perform various adjustments.f Aspect ratio of the image size may shift depending on the correction.[SHIFT](Only for RGB signals and YCBC R/YPBP R signals input)Move the image position vertically or horizontally if the image position projected on the screen is shifted evenwhen the relative position of the projector and the screen is installed correctly.1) Press as to select [SHIFT].2) Press the button.f The [SHIFT] screen is displayed.3) Press asqw to adjust the position.Orientation Operation AdjustmentVertical (up and down)adjustmentPress the a button. The image position moves up.Press the s button. The image position moves down.Horizontal (right and left)adjustmentPress the w button. The image position moves to the right.Press the q button. The image position moves to the left.Notef Depending on the input signal, if the adjustment of [SHIFT] exceeds the effective adjustment range of the input signal, the position of theimage cannot be changed. Please adjust [SHIFT] within an effective adjustment range.[DOT CLOCK](Only for RGB signals and YCBC R/YPBPR signals (except for SYNC ON GREEN) input)Use this function to adjust and minimize the effect of interference caused by projection of patterns consisting ofvertical stripes.The projection of the striped pattern may cause cyclic patterns (noise). Adjust so that the amount of interference isat a minimum. You can adjust the dot clock of image.1) Press as to select [DOT CLOCK].2) Press qw or the button.f The [DOT CLOCK] individual adjustment screen is displayed.3) Press qw to adjust the value.f The adjustment values are [-32] to [+32].
