Panasonic PT-FZ570 Operating Instructions Manual

Also see for PT-FW530: Operating instructions (functional manual)Operating instructions

Contents

Panasonic PT-FZ570 Operating Instructions Manual Manual pdf 47 page image

Chapter 3 Basic Operations — ProjectingENGLISH - 47ProjectingCheck the external device connection (x page 36), power cord connection (x page 41), and switch on theprojector (x page 42) to start projecting. Select the image for projection, and adjust appearance of the projectedimage.Selecting the input signalThe input for projection can be switched. Method to switch the input is as follows.f Press the input selection buttons on the remote control and directly specify the input to project.f Press the button on the control panel to display the input selection screen and select theinput to project from the list.Switching the input directly via remote controlThe input for projection can be switched directly by pressing the input selection button on the remote control.1) Press the input selection (, , , * 1 ,

) buttons.f Switches the input, the input guide of the selected input terminal displayed on the top right of the projectionscreen. Switches the input to HDMI1. The image of the signal being input in the terminal isprojected. Switches the input to HDMI2. The image of the signal being input in the terminal isprojected. Switches the input to DIGITAL LINK. The image of the signal being input in the terminal is projected. *1Switches the input to COMPUTER1 or COMPUTER2. If one input is already selected, it will beswitched to the other input. The image of the signal being input in the <COMPUTER 1 IN> terminal orthe terminal is projected.

Switches the input to VIDEO. The image of the signal being input in the

projected. Switches the input to NETWORK.*1 If the [DISPLAY OPTION] → [COMPUTER IN/OUT]→ [COMPUTER2 SELECT] is set to [COMPUTER1 OUT], the COMPUTER2 INPUTcannot be selected.Attentionf Images may not be projected properly depending on the external device, or the Blu-ray disc or DVD disc, to be played back. Set the [PICTURE]menu → [RGB/YCB C R]/[RGB/YPB PR]. (x page 65)f Confirm the aspect ratio of the projection screen and the image, and switch to an optimum aspect ratio from the [POSITION] menu →[ASPECT]. (x page 73)Notef When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the LAN> terminal, the input on the DIGITAL LINK output supported device changes each time the button is pressed. The inputcan also be changed using the RS-232C control command.For twisted-pair-cable transmitters of other manufacturers, switch the input on the projector to DIGITAL LINK, and then switch the input onthe twisted-pair-cable transmitter.f Configure [COMPUTER1 INPUT SETTING] of the [DISPLAY OPTION] menu → [COMPUTER IN/OUT] (x page 77) to match the signalto be input to the <COMPUTER 1 IN> terminal.f If input signal to the terminal, please set [COMPUTER2 IN] of the [DISPLAY OPTION] menu → [COMPUTERIN/OUT] → [COMPUTER2 SELECT].Remote controlControl panel