Panasonic PT-FZ570 Operating Instructions Manual

Also see for PT-FW530: Operating instructions (functional manual)Operating instructions

Contents

Panasonic PT-FZ570 Operating Instructions Manual Manual pdf 96 page image

Chapter 4 Settings — [PROJECTOR SETUP] menu96 - ENGLISH[COMMAND] Detailed settings of[COMMAND] Description[INPUT][NETWORK] Switches the input to NETWORK.[COMPUTER1] Switches the input to COMPUTER1.[COMPUTER2] Switches the input to COMPUTER2.[HDMI1] Switches the input to HDMI1.[HDMI2] Switches the input to HDMI2.[VIDEO] Switches the input to VIDEO.[DIGITAL LINK] Switches the input to DIGITAL LINK.[INPUT1] - [INPUT10] *1 Switches the input to DIGITAL LINK, and switch the input of thePanasonic twisted-pair-cable transmitter to the specified input.[LAMP POWER] [NORMAL] Sets the lamp brightness to high luminance.[ECO] Sets the lamp brightness to low luminance.[IN STANDBY MODE] [OFF] Audio output is stopped during standby.[ON] Audio is output during standby.[VOLUME] [0] ~ [63] Sets the volume.*1 When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the projector, its inputname is automatically reflected from [INPUT1] to [INPUT10]. If an item where the input name is not reflected is selected, it is disabled.11) Press the button.f The command is fixed and n is displayed at the left of the selected command.12) Press asqw to select [STORE], and press the button.Notef If you attempt to register the setting that would make the lamp turn on for a short time, an error message will be displayed on the screen. Setthe time and the command again.f To delete a command that has been already set, press the button on the remote control while the screen in Step 5) isdisplayed, or select [DELETE] at the screen in Step 6) and press the button.f If multiple commands have been set for the same time, they are executed in chronological order starting from the smallest commandnumber.f The operating time will be the local time. (x page 96)f If an operation is executed with the remote control or the control panel of the projector or with a control command before the command set in[SCHEDULE] is executed, the command set with the schedule function may not be executed.[DATE AND TIME]Set the time zone, date, and time of the built-in clock of the projector.Setting the time zone1) Press as to select [DATE AND TIME].2) Press the button.f The [DATE AND TIME] screen is displayed.3) Press as to select [TIME ZONE].4) Press qw to switch [TIME ZONE].Setting the date and time manually1) Press as to select [DATE AND TIME].2) Press the button.f The [DATE AND TIME] screen is displayed.3) Press as to select [ADJUST CLOCK].4) Press the button.f The [ADJUST CLOCK] screen is displayed.5) Press as to select an item, and press qw to set the local date and time.6) Press as to select [OK], and press the button.