Chapter 2 Getting Started — Setting upENGLISH - 31Setting upInstallation modeThere are four ways to set up the projector. Set the [PROJECTOR SETUP] menu → [PROJECTION METHOD](x page 88) depending on the installation method.Mounting on the ceiling and projecting forward Mounting on the ceiling and projecting from rear(Using the translucent screen)Menu item Method Menu item Method[PROJECTION METHOD] [AUTO] or [FRONT/CEILING] [PROJECTION METHOD] [REAR/CEILING]Setting on a desk/floor and projecting forward Setting on a desk/floor and projecting from rear(Using the translucent screen)Menu item Method Menu item Method[PROJECTION METHOD] [AUTO] or [FRONT/DESK] [PROJECTION METHOD] [REAR/DESK]Notef The projector has a built-in angle sensor. When projecting in front of the screen, if set the [PROJECTOR SETUP] menu→ [PROJECTION METHOD] → [AUTO], the projector’s posture will be detected automatically. When projecting fromrear, please set the [PROJECTION METHOD] to [REAR/DESK] or [REAR/CEILING].rAngle sensorThe range of installation posture detected by the projector’s built-in angle sensor is as follows.In the case of [AUTO], when the projector is placed horizontally upright within ±150°, it will switch to [FRONT/DESK]; when the projector is placed horizontally upside down within ±30°, it will switch to [FRONT/CEILING]automatically. However, the setting range for [FRONT/DESK] is horizontally upright within ±30°.Attentionf The angle sensor cannot detect whether it is the “Installation prohibited posture” in the above picture. Please do not use the projector tiltedat an angle that exceeds ±30° from the vertical plane. It may reduce the life of the components. (x page 18)Projection direction30°30°30°30°150°150°[FRONT/CEILING]Installationprohibited postureInstallationprohibited posture[FRONT/DESK]
