Chapter 3 Basic Operations — Switching on/off the projector46 - ENGLISH2) Press qw to select [OK], and press the button.(Or press the power <v/b> button again.)f Projection of the image will stop, and the power indicator on the projector bodylights in orange. (The fan keeps running.)3) Wait until the power indicator lights or blinks in red.4) Press the side of the switch to turn off the power.Notef Do not switch on the projector and project images immediately after switching off the projector.Turning on the power while the lamp is still hot may shorten the life of the lamp.f For about 90 seconds after the projector is switched off and the luminous lamp cooling is started, the luminous lamp will not light up even ifthe power is switched on. In such a case, switch on the projector again after the power indicator lights in red.f The projector consumes power even when the power <v/b> button is pressed and the projector is switched off if the main powerof the projector is on.When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], use of some functions is restricted,but the power consumption during standby can be conserved.Direct power off functionThe projector can be turned off during projection or immediately after the luminous lamp is turned off by settingthe switch to . In addition, when the projector is mounted on the ceiling or installed in anenvironment where the switch of the projector cannot be easily turned , the power canbe turned off directly using the circuit breaker. It is also safe in case a power outage occurs or the power cord ispulled out immediately after the projector is switched off.Attentionf Do not set the switch to or turn off the power breaker switch in a short time (about 1 minute) after the lamp is lit.Doing so may cause the lamp fail to light while you powering on the projector next time, or result in premature deterioration of the lamp.Notef If the [PROJECTOR SETUP] menu → [INITIAL STARTUP] is set to [LAST MEMORY] and the projector was turned off by using the circuitbreaker directly while projecting during the last time of use, the power indicator will light in green a while after thecircuit breaker is turned on, and then projection of the image will start.f If the projector is cooled with the direct power off function, it may take longer than usual to be ready for projection when the projector isswitched on the next time.
