Chapter 4 Settings — [PROJECTOR SETUP] menuENGLISH - 97f The setting of the date and time will be completed.Setting the date and time automatically1) Press as to select [DATE AND TIME].2) Press the button.f The [DATE AND TIME] screen is displayed.3) Press as to select [ADJUST CLOCK].4) Press the button.f The [ADJUST CLOCK] screen is displayed.5) Press as to select [NTP SYNCHRONIZATION], and press qw to change the setting to [ON].6) Press as to select [OK], and press the button.f The setting of the date and time will be completed.Notef To set the date and the time automatically, the projector must be connected to the network.f If synchronization with the NTP server fails just after [NTP SYNCHRONIZATION] is turned [ON], [NTP SYNCHRONIZATION] will return to[OFF]. Also if [NTP SYNCHRONIZATION] is turned [ON] while the NTP server is not set, [NTP SYNCHRONIZATION] will return to [OFF].f Access the projector via a web browser to set the NTP server. Refer to “[Adjust clock] page” (x page 124) for details.f The [TIME ZONE] setting is reset to the factory default when [INITIALIZE ALL] is executed from the [PROJECTOR SETUP] menu (x page97). However, the date and the time based on the local date and the time setting (Coordinated Universal Time, UTC, Universal Time,Coordinated) will be maintained without being initialized.[INITIALIZE ALL]Return various setting values to their factory default settings.1) Press as to select [INITIALIZE ALL].2) Press the button.f The [INITIALIZE ALL] screen is displayed.3) When the confirmation screen is displayed, press qw to select [OK] and then press the button.f The [NOW INITIALIZING...] screen is displayed and then the [POWER OFF.] screen will be displayed.4) Press the button.f The operation of other buttons is disabled.f The initial setting (display language) screen will be displayed when the projector is switched on the nexttime.Notef The projector will enter the standby status to reflect the setting values when [INITIALIZE ALL] is executed.f When [INITIALIZE ALL] is executed, [STANDBY MODE], [EMULATE], [FILTER COUNTER] and the setting values of [NETWORK] cannot bereturned to the factory default values.For details about the initialization of [NETWORK], please refer to [NETWORK] → [INITIALIZE]. (Æ page 104)
