|
Chapter 4 Settings — [DISPLAY OPTION] menuENGLISH - 854) Press qw to set the time.f The time can be set in 1-minute increments from 1 to 180 minutes.f The factory default value is 10 minutes.Notef [TIMER] is enabled when [MODE] is set to [COUNT DOWN].Using the presentation timer1) Press as to select [P-TIMER].2) Press the button.f The [P-TIMER] screen is displayed.3) Press as to select the item, and press the button.[START] The count is started.[STOP] The count is stopped.[RESTART] The count is resumed.[RESET] The count is reset.f When [START] or [RESTART] is selected, the elapsed time or the remaining time is displayed at the bottomright of the projected image.f When [STOP] is selected, the elapsed time or the remaining time when the count was stopped is displayedat the bottom right of the projected image.f When [RESET] is selected, proceed to Step 4).4) Press the f The P-TIMER function is cancelled.Notef Presentation timer operations are also possible by the button on the remote control. (x page 53)f The security message set in the [SECURITY] menu → [DISPLAY SETTING] (x page 98) is not displayed when the elapsed time orremaining time is displayed.f The elapsed time or remaining time are not displayed when the menu screen is displayed.f The start time becomes “000:00” when [MODE] is set to [COUNT UP].f When [MODE] is set to [COUNT DOWN], the start time becomes the value set at [TIMER].f The time gauge turns clockwise when [COUNT UP] is set, and turns counterclockwise when [COUNT DOWN] is set.Ending the presentation timer1) Press as to select [P-TIMER].2) Press the button.f The [P-TIMER] screen is displayed.3) Press as to select [EXIT].4) Press the button.[OTHER FUNCTIONS]You can perform some of the remote control button operations by using the sub-menu.1) Press as to select [OTHER FUNCTIONS].2) Press the button.f The [OTHER FUNCTIONS] screen is displayed.3) Press as to select the item.[AUTO SETUP]Automatically adjust the resolution, the clock phase and the image position when analog RGB signalsconsisting of bitmap images such as computer signals are being input, or to automatically adjust theimage position when HDMI signals are input.For details, refer to "Using the automatic setup function". (Æ page 51)
|
