Panasonic PT-FZ570 Operating Instructions Manual

Also see for PT-FW530: Operating instructions (functional manual)Operating instructions

Contents

Panasonic PT-FZ570 Operating Instructions Manual Manual pdf 42 page image

Chapter 3 Basic Operations — Switching on/off the projector42 - ENGLISHIndicator status Projector statusGreenLit Projecting.BlinkingThe power is still on while the lamp is turned off. The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] →[POWER MANAGEMENT] is set to [READY].*2The lamp starts work. The projector will project image after a while.*3Orange Lit The projector is preparing to be switched off.The power is switched off after a while. (Changes to the standby mode.)*1 The indicator flashes in the cycle: 2.75 seconds (light) → 0.25 seconds (off).*2 The indicator flashes in the cycle: 2.0 seconds (light) → 2.0 seconds (off).*3 The indicator flashes in the cycle: 0.5 seconds (light) → 0.5 seconds (off).Notef While the power indicator is lit in orange, the fan is running to cool the projector.f For about 90 seconds after the projector is switched off and the luminous lamp cooling is started, the luminous lamp does not light up even ifthe power is switched on. After the power indicator lights or blinks in red, turn on the power again.f The projector consumes power even in standby mode (power indicator lights or blinks in red). Refer to “Powerconsumption” (x page 151) for the power consumption.f The power indicator will blink if the projector receives a remote control signal.f If the power indicator is blinking 3 times in red, consult your dealer.Switching on the projectorBefore switching on the projector, make sure all the other devices are correctly connected (x page 36) andremove the lens cover first.2)4)4)3)1)1) Connect the power cord to the projector body.2) Connect the power plug to an outlet.3) Press the side of the

switch to turn on the power.f The power indicator lights or blinks in red, and the projector enters the standbymode.4) Press the power <v/b> button.f The power indicator lights in green and the image is soon projected on the screen.Attentionf Be sure to remove the lens cover before starting projection.Notef If the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], it may take approx. 10 seconds longerbefore the projector starts projecting after the power is turned on, compared with when [NORMAL] is set.f If the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [NORMAL], it may take approx. 1 minute toenable the network function after connecting the power cord.f If the [PROJECTOR SETUP] menu → [INITIAL STARTUP] is set to [LAST MEMORY] and the projector was turned off by using the circuitbreaker directly while projecting during the last time of use, the power indicator will light in green a while after thecircuit breaker is turned on, and then projection of the image will start.