Panasonic PT-FZ570 Operating Instructions Manual

Also see for PT-FW530: Operating instructions (functional manual)Operating instructions

Contents

Panasonic PT-FZ570 Operating Instructions Manual Manual pdf 88 page image

Chapter 4 Settings — [PROJECTOR SETUP] menu88 - ENGLISH[LAST MEMORY] Starts in the condition that before disconnected the power cord or turn off the breaker.[STANDBY] Starts up in the standby mode.[ON] Starts the projection immediately.[PROJECTION METHOD]Set the projection method in accordance with the installation status of the projector.Change the projection method if the screen display is upside down or inverted.1) Press as to select [PROJECTION METHOD].2) Press qw to switch the projection method.f The items will switch each time you press the button.[AUTO] The projector’s posture can be detected automatically by the built-in angle sensor, then switch to[FRONT/DESK] or [FRONT/CEILING]. When projecting in front of the screen, please set to [AUTO].[FRONT/DESK] When installing the projector on the desk, etc., in front of the screen.[FRONT/CEILING] When installing the projector in front of the screen with the Ceiling Mount Bracket (optional).[REAR/DESK] When installing the projector on the desk, etc., behind the screen (with a translucent screen).[REAR/CEILING] When installing the projector behind the screen (with a translucent screen) with the Ceiling MountBracket (optional).Notef When set to [AUTO], front projection or rear projection cannot be detected. When projecting from rear, please set the [PROJECTIONMETHOD] to [REAR/DESK] or [REAR/CEILING].f As for the range of installation posture detected by the projector’s built-in angle sensor, please refer to “Angle sensor”. (x page 31)[LAMP POWER]Switch the brightness of the lamp according to the operating environment of the projector or the purpose.1) Press as to select [LAMP POWER].2) Press qw to switch the item.f The items will switch each time you press the button.[NORMAL] Select when high luminance is required.[ECO] Select when high luminance is not required.Notef Set it to [ECO] rather than [NORMAL] when you want to reduce power consumption, extend the life of lamp and reduce operation noise.f The [LAMP POWER] is fixed to [ECO] when the [PICTURE] menu → [PICTURE MODE] (x page 61) is set to [DICOM SIM.].f The [LAMP POWER] changes to [ECO] forcibly to protect the projector when the operating environment temperature becomes 35 °C (95 °F)or higher (30 °C (86 °F) or higher when used at high altitude). And, even if the [PROJECTOR SETUP] menu → [LAMP POWER] is set to[NORMAL], the [LAMP POWER] changes to [ECO] automatically.[ECO MANAGEMENT]This function optimizes lamp power according to the operating status to reduce power consumption.Setting [AUTO POWER SAVE]Set whether or not to enable the [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION] and [AV MUTEDETECTION] functions.1) Press as to select [ECO MANAGEMENT].2) Press the button.f The [ECO MANAGEMENT] screen is displayed.3) Press as to select [AUTO POWER SAVE].4) Press qw to switch the item.f The items will switch each time you press the button.[ON] Enables the energy conservation setting.[OFF] Disables the energy conservation setting.