Setting up the printer2-12Setting up the printerYour new printer is easy to install and set up. This chapter tells you how to set up theprinterand start printing right away. If this is your first printer, you should read theentire chapter before attempting to use the printer. In this chapter, you will learn howto:z Unpack, assemble, and select a good location for the printerz Identify the printer’s major partsz Connect the power cord and the interface cablez Test the printer before connecting it to your computerz Select an emulation and print a sample page using your softwareIf you have a problem while setting up the printer, review the section “Solving Prob-lems” in Chapter 7. If the problem persists, contact your dealer or service.Selecting a locationThis printer is suitable for most business, office, and home environments. To obtainpeak performance from the printer, select a location that meets the following guide-lines:3 Place the printer on a sturdy, level surface.3 Place the printer near a well-grounded AC power outlet.3 Ensure easy access to the front and rear of the printer by leaving several inches ofspace around the printer. Do not block the air vents on the front, left, and right sidesof the printer.3 Do not place the printer in direct sunlight or near heaters.3 Make sure that the room is well-ventilated and free from excessive dust.3 Do not expose the printer to extremes of temperature and humidity.3 Use only the power cord supplied with the printer or recommended by your dealer.Do not use an extension cord.3 Do not plug the printer into a power outlet that is shared with heavy industrial equip-ment, such as motors, or appliances, such as copiers or coffee makers. Such equip-ment often emits electrical noise or causes power degradation.
