Setting up the printer2-14Removing the shutterAttaching the shutterCAUTION:Take care not to use excessive force when pushing the back of the shuttertoward the front of the printer. Otherwise, the shutter tabs may be dam-aged.To reattach the shutter, tilt the shutter and insert one of its convex partsinto the installation hole of the printer, and then insert the other part inthe other hole. After inserting both convex parts, lower and push theshutter in to its original position.1. Open the shutter.2. Gently push the back end of theshutter toward the front of theprinter.3. While holding the shutter in theposition described in step 2, rotateit in the manner shown in theShutter(a)Mounting slots TabsShutter5. Tilt the shutter and pass the shuttertabs through the mounting slots,starting with the slot on side (a)shown in the figure on the left. Theorder in which the shutter tabs are
