Setting up the printer2-4Assembling the printerThis section explains how to install the cut sheet stand and ribbon cartridge.Installing the Cut Sheet StandThe cut sheet stand enables smooth feeding of both single sheets and continu-ousforms. Install the cut sheet stand as described below:1. Referring to the following figure, locate the two grooved notches on the top ofthe printer, behind the top cover. Note that each notch has a front groove and arear groove.2. Locate the two mounting pins on each side of the cut sheet stand.Installing the cut sheet stand3. Hold the cut sheet stand at an angle over the top of the printer. Slide the mount-ing pins into the long, front grooves of the notches. This is the cut sheet stand'sup position, used for printing single sheets.To rotate the cut sheet stand to its down position, grasp it at the sides and lift it upuntil the two upper mounting pins clear the front notches. Rotate the cut sheetstand backward to place the upper mounting pins in the rear grooves.Cut sheet standMounting pins
