Paper Handling3-15NOTE: When you use continuous forms, make sure that the edges of both left andright paper guides do not touch the paper. Slide both paper guides flushagainst the ends of both sides.Adjustment of the paper guidesAdjusting the Tear-off positionWhen the FF/Load button is used to advance the paper to cut it, the paper cut posi-tion and the perforation position may not match. In such cases, adjust their positionsby using the following procedure.Adjustment procedure1. Use the FF/Load button to advance the paper to its cut position.2. Press Park and FF/Load buttons simultatneously to enter adjustment mode.3. Adjust the Tear-off position by using the following buttons:z Ç button: Pressing this button once extends the paper feed amount by 1/180inches.z È button: Pressing this button once reduces the paper feed amount by 1/180inches.zExit/Save button: Saves the adjusted value and exits the adjustment mode.zSetup/Quit button: Exits the adjustment mode without saving the adjusted value.NOTE: The adjustment range is plus or minus 63/180 inches (approximately 9 mm).When it is exceeded, an alarm beeps.Good UnacceptableRight paperguideLeft paperguideContinuousformCut sheetstand
