Paper Handling3-8Using Single SheetsThis section describes how to load paper in the cut sheet stand. The cut sheet standallows paper to be loaded manually, one sheet at a time.Loading a Single Sheet of PaperTo load a sheet of paper into the cut sheet stand:1. Make sure that the printer is turned on. Check that rear-fed continuous forms areretracted to the park position. (For details, see the section “Unloading Continu-ous Forms” later in this chapter.)2. If necessary, reset the paper thickness lever. (See the section “Adjusting forPaper Thickness” earlier in this chapter.)3. Move the paper select lever forward. (This lever is at the top left part of theprinter.)4. Raise the cut sheet stand. Position the left paper guide in accordance with theNote below. Note that the movable range of the paper guide is limited.NOTE: Below the left paper guide, the cut sheet stand has a scale graduated in unitsof 0.1 inch. When the left paper guide is positioned all the way to the right,the left margin is 5 mm (0.2 inch). To help align paper, also use the inch-based ruler on the top cover of the printer. The gradations on the ruler arefor 10 columns per inch.Preparing to load a sheet of paperLeft margin(minimum)
