C-27Command SetsFunction CommandEpson ESC/P2 Quick Reference GuideThis section describes the printer commands for the Epson ESC/P2 protocol. Asterisks inthe “Function” column indicate extended commands that are not supported by the originalprinter. See the Programmer’s Reference Manual for detailed information on using thesecommands.Function CommandPrint Mode ControlDouble-strike (bold) printing on ESC GDouble-strike (bold) printing off ESC HEmphasized (shadow) printing on ESC EEmphasized (shadow) printing off ESC FItalic printing on ESC 4Italic printing off ESC 5Select character style ESC q (n)n = 0: Normal1: Outlined2: Shaded3: Outlined and shadowedOne-line double-width characters on SO or ESC SOOne-line double-width characters off DC4Double-width characters on/off ESC W (n)(on: n = 1, off: n = 0)Double-height characters on/off ESC w (n)(on: n = 1, off: n = 0)Condensed characters on SI or ESC SICondensed characters off DC2Subscript or superscript printing on ESC S (n)(subscript: n = 1, superscript: n = 0)Subscript and superscript printing off ESC TUnderline on/off ESC - (n)(on: n = 1, off: n = 0)Select line ESC ( - (n1 ) (n2 ) (d1 ) (d2) (d3)n1 = 3, n2 = 0, d1 = 1d2 = 0: Ignore command1: Underline2: Strike through3: Overscored3 = 0 or 4: Cancel line selection1: Single line2 or 3: Double line5: Single-dotted line6 or 7: Double-dotted line
