|
Using Set-Up Mode5-53. After selecting the desired values, press the Exit/Save button to reprint the menu where the red cursor is positioned beneath SAVE&EXIT.For each option, the bolded value is the current default value (the value currentlysavedin the printer’s permanent memory). In the previous example, the defaultvalues are PORT DEPND (Port Dependent) for protocol selection and DRAFT(Draft) for font selection.Example: Changing the Vertical PitchTo become familiar with the Set-Up mode, try the following example. This exampleshows how to change the vertical pitch in Macro 2 from 6 lines per inch to 8 lines perinch.1. Enter the Set-Up mode.Turn the printer off and back on while pressing the Set-Up/Quit button until theprinter beeps.2. Select the Macro 2 function.Wait for the printer to stop printing and press the Æ button once to position thered cursor on the plastic guide of the print head under MACRO 2. Press the Çbutton or the È button to select the Macro 2 function and print the COL> option and its values.3. Print the menu of the vertical pitch option.Since you only want to change the vertical pitch, press the È button to select thecurrent protocol. Bolded PORT DEPND is underlined, and the next option is printed. (The bolded value indicates the current setting, andthe underlined value is the new setting.) Repeatedly press the È button in thesame way until the option and its values are printed.4. Change the vertical pitch from 6 to 8 lines per inch.Press the Æ button once to position the red cursor beneath 8 LPI. Press the Èbutton to select 8 LPI. 8 LPI is underlined, and the next option, PITCH>, and its values are printed.5. Exit the Macro 2 function.Since you do not want to make any other changes in MACRO 2, press the Exit/Save button. The menu is then reprinted, and the red cursor ispositioned beneath SAVE&EXIT.
|
