102Making Copies AddedFeaturesBasicFeaturesImageQuality Stored JobTemplatesOutputFormat5.6 Punching HolesWhen the optional finisher is installed, this feature allows you to output copies with punchedholes.You can select the number of punch holes from 2 Holes or 4 Holes.● Suitable paper sizes for punching and punch positionsThe following paper sizes and positions are suitable for punching:● Document orientationFollow the diagram below for loading in the Head to Left orientation:● When the punch scrap container is full, the machine will not start even if you press the Start button. Empty the punch scrapcontainer. For details, refer to “10.6 Emptying Punch Scrap Container”.● When the positions for punching and stapling are in conflict (e.g. stapling on the top left and punching on the right), the machinewill not start even if you press the Start button. Check the positions again.● Punching cannot be carried out if tray 5 (bypass) has been selected.● When option tray 7 is selected, punch positions are limited as follows. This limitation can be changed by means of a customerengineer setting. Contact our Customer Support Center for details.• When Head to Top is selected for document orientation: The left side• When Head to Left is selected for document orientation: The top side● The Transparency option cannot be selected together with Repeat Image.PositionPaper size Top Left Right2 HolesB5 portrait,A4 portrait,8.5×11" portraitA4, B4, A3,11×17"4 HolesA4 portrait,8.5×11" portraitA3, 11×17"OutputOptionalOn the document glass In the DADF
