Yaesu FT DX 3000 Operating Manual

Also see for FT DX 3000: Operating manual Operating manual Operating manual Operating manual Operating manual

Page 101FT DX 3000 O peraTing M anualM eMory Scan1. Set the transceiver up in the “Memory” mode bypressing the [V/M] button, if necessary.a dvice :If you can not enter the “Memory” mode, check tosee if the transceiver is in VFO-B mode (the green[VFO-B(RX)] Indicator/Switch is illuminated). If so,press the [VFO-A(RX)] Indicator/Switch to returnoperation to VFO-A. Now, press the [V/M] button toenter the “Memory” mode.2. Rotate the [RF/SQL] knob so that the backgroundnoise is just silenced.3. Press and hold in the microphone [UP] or [DWN]Ney for one second to start scanning in the specifieddirection.a dvice : If the scanner halts on an incoming signal, thedecimal point between the “MHz” and “kHz”digits of the frequency display will blink. If the incoming signal disappears, scanning willresume in aEout fiYe seconds.4. To cancel scanning, press the [PTT] witch.a dvice : During Memory Group operation, only the channelswithin the current Memory Group will be scanned. If the scan has paused on a signal, pressing the mi-crophone [UP] or [DWN] key will cause scanning toresume instantly. If you press the microphone PTT switch duringscanning, the scanner will halt at once. However,pressing the PTT switch during scanning will notcause transmission. You may select the manner in which the scanner re-sumes while it has paused on a signal, using Menuitem “046 MIC SCAN RESUME”. During memoryscanning, the default “TIME” (5 sec) setting willcause the scanner to resume scanning after fiveseconds. However, you may change this setting toresume only after the carrier has dropped out, if youlike.Quick Point:If you have no interest in scanning, and wish to prohibitthe microphone [UP]/[DWN] keys from initiating scan-ning, you may disable scanning control from the mi-crophone using Menu item “045 MIC SCAN” (set it to“DISABLE”).VFO and M eMOry S canning[V/M] Button[VFO-A(RX)] Button[VFO-B(RX)] Button[RF/SQL] Knob