2-15CABLE ROUTING DIAGRAM SPEC1 Brake hose holder2 Master cylinder3 Brake hose4 Reservoir hose5 Hose guide6 Clamp7 High tension cord8 Ignition coil9 Clutch cable0 Cable guideq Ground leadw Radiator breather hosee CDI magneto leadr Throttle cablet CDI unit leady “ENGINE STOP” button leadu Fuel tank damperi Engine bracketA Pass the brake hose into thebrake hose holder.B If the brake hose contacts thespring (rear shock absorber),correct its twist.C Install the brake hose so that itspipe portion directs as shownand lightly touches the projec-tion on the master cylinder.D Pass the reservoir hosebetween the brake hose andswingarm bracket.E Pass the reservoir hose into thehose guide.F Clamp the high tension cord,throttle cable, TPS (throttle posi-tion sensor) and solenoid valvelead so that the high tensioncord does not contact theengine bracket installation nuts.G Fasten the ground lead togetherwith the front installation portionof the ingnition coil.H Pass the clutch cable into thecable guide.I Position the CDI magneto leadcoupler between the radiators.J Install the brake hose to thecaliper with the paint on the pipefacing the caliper and with thepipe contacting the caliper pro-jection.K Pass the radiator breather hosebetween the frame and radiatorhose so that it is not kinked orwedged.L Pass the throttle cable, CDI unitlead, “ENGINE STOP” buttonlead and clutch cable betweenthe fuel tank damper tube ends.
