3-36STEERING HEAD INSPECTION AND ADJUSTMENT INSPADJ9Loosen the ring nut one turn.9Retighten the ring nut using the ring nutwrench.wAvoid over-tightening.9Check the steering shaft by turning it lock tolock. If there is any binding, remove thesteering shaft assembly and inspect thesteering bearings.9Install the plain washer 5, handle crown 6,plain washer 7, steering shaft nut 8, Steer-ing shaft cap 9, handlebar 0, handlebarholder q and number plate w.NOTE:9The upper handlebar holder should beinstalled with the punched mark a forward.9Install the handlebar so that the marks b arein place on both sides.9Insert the end of the fuel breather hose einto the hole in the steering shaft cap.cCFirst tighten the bolts on the front side ofthe handlebar holder, and then tighten thebolts on the rear side.Ring nut wrench:YU-33975/90890-01403Ring nut (initial tightening):38 Nm (3.8 m•kg, 27ft•lb)Steering shaft nut:145 Nm (14.5 m•kg, 105 t•lb)Handlebar upper holder:28 Nm (2.8 m•kg, 20 ft•lb)Pinch bolt (handle crown):23 Nm (2.3 m•kg, 17 ft•lb)Number plate:7 Nm (0.7 m•kg, 5.1 ft•lb)Ring nut (final tightening):7 Nm (0.7 m•kg, 5.1 ft•lb)
