Yamaha YZF-R1B 2012 Service Manual

Also see for YZF-R1 2012: Service manual

Contents

CLUTCH5-676. Install:• Bearing(into the pressure plate 1)• Pull rod• Pressure plate 17. Install:• Clutch springs• Clutch spring bolts “1”TIPTighten the clutch spring bolts in stages and ina crisscross pattern.8. Install:• Dowel pins• Clutch cover gasket• Clutch cover “1”TIP• Position the pull rod so that the teeth “a” facetowards the rear of the vehicle. Then, installthe clutch cover.• Apply locking agent (LOCTITE®) to thethreads of only the clutch cover bolts “b”shown in the illustration.• Tighten the clutch cover bolts in stages andin a crisscross pattern.9. Install:• Pull lever spring “1”• Pull lever “2”• Washer• CirclipTIP• The end of the pull lever should be closest tothe clutch cover match mark “a” when thereis no free play of the pull lever.• Make sure that the pull rod teeth and pulllever shaft pinion gear are engaged.10. Adjust:• Clutch cable free playRefer to “ADJUSTING THE CLUTCHCABLE FREE PLAY” on page 3-14.Clutch spring bolt10 Nm (1.0 m·kgf, 7.2 ft·lbf)Clutch cover bolt12 Nm (1.2 m·kgf, 8.7 ft·lbf)NewNewManuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keysemail: info@motomatrix.co.uk