EXE_OPCLOSEPOSEXE_OPOPENPOSAdaptivePulse=FALSEtOpenPulsetOpenPulseAdaptivePulse=TRUEtStartMove timeren05000099.vsdIEC05000099 V1 ENFigure 123: Open command with open position indicationError handlingDepending on the error that occurs during the command sequence the error signal willbe set with a value. Table 196 describes vendor specific cause values in addition tothese specified in IEC 61850-8-1 standard. The list of values of the “cause” are inorder of priority. The values are available over the IEC 61850. An output L_CAUSEon the function block indicates the latest value of the error during the command.Table 196:Vendor specific cause values for Apparatus control in priority orderApparatus controlfunctionDescription–22 wrongCTLModel–23 blockedForCommand–24 blocked-for-open-command–25 blocked-for-close-command–30 longOperationTime–31 switch-not-start-moving–32 persistent-intermediate-state–33 switch-returned-to-initial-position–34 switch-in-bad-state–35 not-expected-final-position10.3.9.3 Circuit switch SXSWIThe users of the Circuit switch (SXSWI) is other functions such as for example, switchcontroller, protection functions, autorecloser function, or a 61850 client residing inanother IED or the operator place. SXSWI executes commands, evaluates blockconditions and evaluates different time supervision conditions. Only if all conditionsSection 10 1MRK 511 287-UEN AControl256Technical manual
