EXE_OPCLOSEPOSEXE_OPOPENPOSAdaptivePulse=FALSEtOpenPulsetOpenPulseAdaptivePulse=TRUEtStartMove timeren05000099.vsdIEC05000099 V1 ENFigure 127: Open command with open position indicationError handlingDepending on the error that occurs during the command sequence the error signal willbe set with a value. Table 197 describes vendor specific cause values in addition tothese specified in IEC 61850-8-1 standard. The list of values of the “cause” are inorder of priority. The values are available over the IEC 61850. An output L_CAUSEon the function block indicates the latest value of the error during the command.Table 197:Values for "cause" signal in priority orderApparatus controlfunctionDescription–22 wrongCTLModel–23 blockedForCommand–24 blocked-for-open-command–25 blocked-for-close-command–30 longOperationTime–31 switch-not-start-moving–32 persistent-intermediate-state–33 switch-returned-to-initial-position–34 switch-in-bad-state–35 not-expected-final-position10.3.9.4 Bay control QCBAYThe functionality of the Bay control (QCBAY) function is not defined in the IEC61850–8–1 standard, which means that the function is a vendor specific logical node.Section 10 1MRK 511 287-UEN AControl260Technical manual
