5. After entering the switch settings, press andrelease all three buttons at the same time.The indicator lights will turn on.6. Press and hold the button you would like touse to control the garage door until thegarage door moves. The indicator light abovethe selected button should slowly blink.You may need to hold the button from five to55 seconds.7. Immediately release the button when thegarage door moves. The indicator light willblink rapidly until programming is complete.8. Press and release the button again. Thegarage door should move, confirming thatprogramming is successful and complete.To program another device such as an additionalgarage door opener, a security device, orhome lighting, repeat Steps 1–8, choosing adifferent function button in Step 6 than what youused for the garage door opener.Programming Universal HomeRemote — Rolling CodeRolling code garage door openers are used forgarage doors produced after 1996 and arecode protected. Rolling code means the codedsignal is changed every time your remote controlgarage door opener is used.Programming a rolling code garage door openerinvolves time-sensitive actions, so read theentire procedure before you begin. If you do notfollow these actions, the device will time outand you will have to repeat the procedure.140
