Fax Header Name Allows you to enter a name that will be printed on the header of faxes.Line Type Sets the default line type; PSTN or PBX.Line Monitor Sets the volume of the line monitor, which audibly monitors a transmission through the internalspeaker until a connection is made.DRPD Pattern Sets the Distinctive Ring Pattern Detection (DRPD) setting from Pattern1 to Pattern7.DRPD is a service provided by some telephone companies.Receive Mode Telephone Automatic fax reception is turned off. You can receive a fax by picking up thehandset of the external telephone and then pressing a remote receive code, or bytapping Manual Receive in On Hook and then tapping Receive. Fordetails about Manual Receive, see "Receiving a Fax Manually in theTelephone Mode."Fax* Automatically receives faxes.Telephone/Fax When the printer receives an incoming fax, the external telephone rings for thetime specified in Auto Receive Tel/Fax, and then the printer automaticallyreceives a fax. If an incoming call is not a fax, the printer beeps from the internalspeaker indicating that the call is a telephone call.Ans Machine/Fax The printer can share a telephone line with an answering machine. In this mode,the printer will monitor the fax signal and pick up the line if there are fax tones. Ifthe telephone communication in your country is serial, this mode is notsupported.DRPD Before using the Distinctive Ring Pattern Detection (DRPD) option, a distinctivering service must be installed on your telephone line by the telephone company.After the telephone company has provided a separate number for faxing with adistinctive ring pattern, configure the fax setup to monitor for that specific ringpattern.Ring Tone Volume Sets the volume of the ring tone, which indicates that an incoming call is a telephone call through theinternal speaker when Receive Mode is set to Telephone/Fax.Auto Receive Fax Sets the interval at which the printer goes into the fax receive mode after answering an incoming call.Auto Receive Tel/Fax Sets the interval at which the printer goes into the fax receive mode after the external telephonereceives an incoming call.Auto Receive Sets the interval at which the printer goes into the fax receive mode after the external answeringAnswer/Fax machine receives an incoming call.Junk Fax Setup Sets whether to reject unwanted faxes by accepting only the faxes from the numbers registered in thePhone Book2 Sided Printing Sets whether to print on both sides of a sheet of paper.Remote Receive Sets whether to receive a fax by pressing a remote receive code on the external telephone.Remote Receive Tone Sets a 2-digit remote receive code when Remote Receive is On.Discard Size Sets whether to delete text or images at the bottom of a fax page when the entire page does not fitonto the output paper. Selecting Auto Reduction automatically reduces the fax page to fit it onto theoutput paper, and does not discard any images or text at the bottom of the page.Sent Fax Forward Sets whether to forward incoming faxes to a specified destination.Forwarding Number Allows you to enter the fax number of the destination to which incoming faxes will be forwarded.Forwarding E-mail Allows you to enter the e-mail address to which incoming faxes are to be forwarded.Address 1Forwarding E-mail Allows you to enter the e-mail address to which incoming faxes are to be forwarded.Address 2Forwarding E-mail Allows you to enter the e-mail address to which incoming faxes are to be forwarded.Address 3Dell™ Printer Configuration Web Tool146
