SNMPPurpose:To configure the detailed settings of SNMP.Values:SNMP Configuration Enable SNMP v1/v2cProtocolSelect the check box to enable the SNMP v1/v2c protocol.Edit SNMP v1/v2cPropertiesClick to display the SNMP v1/v2c page and to edit the setting of SNMPv1/v2c protocol from the page.Enable SNMP v3ProtocolSelect the check box to enable the SNMP v3 protocol.Edit SNMP v3PropertiesClick to display the SNMP v3 page and to edit the setting of SNMP v3protocol from the page.You can click this item only when SSL communication is enabled.SNMP v1/v2cPurpose:To edit the detailed settings of SNMP v1/v2 protocol.To enter this page, click Edit SNMP v1/v2 Properties in the SNMP page.Values:Community Name Community Name(Read only) *1Sets the community name to access (read only) data using up to 31alphanumeric characters.The original setting will remain valid if no input is made. Charactersentered for community name in the previous settings will not be displayedon the screen. The default Read Community is public.Re-enter CommunityName (Read only)*1Enters the community name to access (read only) data again to confirm it.Community Name(Read/Write) *1Sets the community name to access (read and write) data using up to 31alphanumeric characters.The original setting will remain valid if no input is made. Charactersentered for community name in the previous settings will not be displayedon the screen. The default Read/Write Community is private.Re-enter CommunityName (Read/Write) *1Enters the community name to access (read and write) data again toconfirm it.Community Name(Trap) *1Sets the community name used for trap up to 31 alphanumeric characters.The original setting will remain valid if no input is made. Charactersentered for Community Name (Trap) in the previous settings will not bedisplayed on the screen. The default Trap Community is " " (NULL).Re-enter CommunityName (Trap)*1Enters the community name used for trap again to confirm it.Dell™ Printer Configuration Web Tool 165
