Gateway Address When an IP address is being set manually, the gateway address is specifiedusing the format nnn.nnn.nnn.nnn. Each octet that makes upnnn.nnn.nnn.nnn is a value in the range of 0 to 254. 127 and any value in therange of 224 to 254 cannot be specified for the first octet of a gatewayaddress.IPsecNOTE: IPsec feature is available only when IPsec is enabled on the Dell Printer Configuration Web Tool.Purpose:Disables IPsec.Reset WirelessNOTE: Reset Wireless feature is available only when the printer is connected using the wireless network.Purpose:To initialize wireless network settings. After executing this function and rebooting the printer, all wireless networksettings are reset to their default values.Connection SpeedNOTE: Connection Speed feature is available only when the printer is connected using the wired network.Purpose:To specify the communication speed and the duplex settings of Ethernet. The change becomes effective after theprinter is turned off and then on again.Values:Auto* Detects the Ethernet settings automatically.10BASE-T Half Uses 10BASE-T Half-duplex.10BASE-T Full Uses 10BASE-T Full-duplex.100BASE-TX Half Uses 100BASE-TX Half-duplex.100BASE-TX Full Uses 100BASE-TX Full-duplex.1000BASE-T Full Uses 1000BASE-T Full-duplex.Wi-Fi DirectNOTE: When the optional wireless adapter is attached and the Ethernet cable is disconnected, Wi-Fi Direct is displayed.Purpose:To configure the Wi-Fi Direct network settings.Values:Wi-Fi Direct Disable * Disables the Wi-Fi Direct network.Enable Enables the Wi-Fi Direct network.Group Role Auto Automatically resolves the group role for Wi-Fi Direct.Group Owner* Sets the printer as the Group Owner when using Wi-Fi Direct. Setting theprinter to become the group owner makes it possible for devices to discoverthis printer. The SSID of the printer will be then displayed in the list ofwireless networks on your Wi-Fi mobile device.Understanding the Printer Menus228
