Wiring ASDA-B2-F3-2 September, 201533.1 Connections3.1.1 Connecting to Peripheral Devices100 W ~ 1.5 kW Single-/Three-phase 200 ~ 230 V2 kW ~ 3 kW Three-phase 200 ~ 230 VIt could prevent the instantaneousexcessive current caused by short-circuitor from damaging the servo drive whenpower is on / off.PowerNo Fuse Breaker (NFB)CN2 ConnectorMotor poweroutput U, V, WL1cCN1CN2CN3CN6Servo MotorCN6 Connector(DMCNET)P+CRegenerativeResistor (Option)UWVP+CDΘRSTL2cIt can connect to Delta’s PLC controlleror other brands of NC controllers.Host ControllerMagnetic Contactor (MC)When an alarm occurs, it outputsALRM signal and disconnect thepower of the servo drive.1. For MODBUS communication andsupports RS-2322. Use ASDA-Soft to conduct tuning, parameterssetting and control.CN3 ConnectorEMI FilterCN1 I/O ConnectorTo prevent the energy from flowingback caused by motor brake andresult in error, please connect the Pand C end of the servo drive toexternal regenerative resistor, andthe contact of P and D end shouldbe opened. If using the internalregenerative resistor, please makesure the contact of P and D endshould be short-circuited and thecontact of P and C end should beopened.++++Installation notes:1. Check if the power and wiring among R, S, T and L 1c , L 2c are correct.2. Please check if the output terminal U, V, W of the servo motor is correctly wired. Incorrectwiring may disable the operation of the motor or cause malfunction, triggering AL031(Incorrect wiring of the motor power line U, V, W, GND).3. When applying to the external regenerative resistor, the contact between P and Dshould be opened and the external regenerative resistor should connect to terminal Pand C. When applying to the internal regenerative resistor, the contact between P and Dshould be short-circuited and the contact between P and C should be opened.4. When an alarm occurs or the system is in emergency stop status, use ALARM or WARN tooutput and disconnect the power of magnetic contactor in order to disconnect the power ofservo drive.