3 . I ns t r uc ti on Se t3- 1 7 3API Mnemonic Operands Function ControllersES2/EX2 SS2 SA2SESX268 DTM P Data Transformand MoveTypeOPBit Devices Word devices Program StepsX Y M S K H KnX KnY KnM KnS T C D E F DTM: 9 stepsS *D *m * * *n * * *PULSE 16-bit 32-bitES2/EX2 SS2 SA2SE SX2 ES2/EX2 SS2 SA2SE SX2 ES2/EX2 SS2 SA2SE SX2Operands:S: Start device of the source data stack D: Start device of the destination data stackm: Transformation mode n: Length of source data stackExplanations:1. For parameter settings of operand m, please refer to the following description. K, H, D devicescan be specified by operand m. If the set value is not in the available range, no transformationor move operation will be executed and no error will be detected.2. K, H, D devices can be specified by operand n, which indicates the length of the source datastack. The available range for n is 1~256. If the set value falls out of available range, PLC willtake the max value (256) or the min value (1) as the set value automatically.3. The parameter settings and series to support the m operand are listed below:Parameters DescriptionsK0 Transform 8-bit data into 16-bit data (Hi-byte, Lo-byte)K1 Transform 8-bit data into 16-bit data (Hi-byte, Lo-byte)K2 Transform 16-bit data into 8-bit data (Hi-byte, Lo-byte)K3 Transform 16-bit data into 8-bit data (Hi-byte, Lo-byte)K4 Transform 8-bit HEX data into ASCII data (higher 4 bits, lower 4 bits)K5 Transform 8-bit HEX data into ASCII data (higher 4 bits, lower 4 bits)K6 Transform 8-bit ASCII data into HEX data (higher 4 bits, lower 4 bits)K7 Transform 8-bit ASCII data into HEX data (higher 4 bits, lower 4 bits)K8 Transform 8-bit GPS data into 32-bit floating point dataK9Calculate the optimal frequency functionAvailable for ES2/EX2 V1.2, SS2/SA2/SX2/SE V1.0K11Conversion from local time to local sidereal time (longitude)Available for SA2 V1.0, SX2 V1.2, ES2/EX2 V2.0, SS2/SE V1.0
