DVP- ES2/ EX2/ SS2/ SA2/ SX2/ SE&TP O pe r a t i on Ma nua l - Pr ogr am m i ng2- 10SpecificationsWordRegisterT Current value T0~T255, 256 wordsC Current value C0~C199, 16-bit counter, 200 wordsC200~C254, 32-bit counter, 55 wordsD DataregisterGeneralD0~D407, 408 words, (*1)D600~D999, 400 words, (*1)D3920~D9799, 5880 words, (*1)D10000~D11999, 2000 words, (*1)Total12000 pointsLatched D408~D599, 192 words, (*2)D2000~D3919, 1920 words, (*2)Special D1000~D1999, 1000 words, someare latchedRight-side specialmodule D9900~D9999, 100 words, (*1) (*5)Left-side specialmodule D9800~D9899, 100 words, (*1) (*6)Index E0~E7, F0~F7, 16 words, (*1)PointerN Master control loop N0~N7, 8 pointsP Pointer P0~P255, 256 pointsI InterruptServiceExternal interruptI000/I001(X0), I100/I101(X1), I200/I201(X2),I300/I301(X3), I400/I401(X4), I500/I501(X5),I600/I601(X6), I700/I701(X7), 8 points (01: rising-edge trigger , 00: falling-edge trigger )Timer interruptI602~I699, I702~I799, 2 points (Timer resolution =1ms)I805~I899, 1 point (Timer resolution = 0.1ms)(Supported by V1.60 and above)High-speedcounter interruptI010, I020, I030, I040, I050, I060, I070, I080, 8pointsCommunicationinterrupt I150 (COM2), I160 (COM3), 2 points, (*3)ConstantK DecimalK-32,768 ~ K32,767 (16-bit operation),K-2,147,483,648 ~ K2,147,483,647 (32-bitoperation)H Hexadecimal H0000 ~ HFFFF (16-bit operation),H00000000 ~HFFFFFFFF (32-bit operation)Serial PortsCOM1: built-in USB (Slave)COM2: built-in RS-485 (Master/Slave)COM3: built-in RS-485 (Master/Slave)Ethernet: built-in Ethernet (Please refer to AppendixB for more information.)COM1 is typically the programming port.Real Time Clock Year, Month, Day, Week, Hours, Minutes, SecondsSpecial I/O ModulesRight side: Up to 8 I/O modules can be connectedLeft side: Up to 8 high-speed I/O modules can beconnectedNotes:1. Non-latched area cannot be modified2. Latched area cannot be modified3. COM2: built-in RS485 port. COM3: built-in RS485 port.4. There are 8 input points (X0~X7) and 4 output points (Y0~Y3) in an SE MPU. An SE MPUoccupies 16 input points (X0~X17) and 16 output points (Y0~Y17). Extension input points startfrom X20, and output points start from Y20.5. If an SE series MPU is connected to a right-side special module, and M1183 is Off, the rangeof data registers can be used. Every special module connected to an SE series MPU occupiesten data registers.
