1GENERALINFORMATIONCalibration Certificate1. Introduction1.2 new features of the dsp7000Magtrol’s new Model DSP7000 Dynamometer Controller is an upgraded version of the DSP6001,providing superior motor testing capabilities by using state-of-the-art digital signal processingtechnology. Designed for use with any Magtrol hysteresis, Eddy-Current or Powder brakeDynamometer, Magtrol In-Line Torque Transducer or auxiliary instrumentation, the DSP7000 bothcontrols the dynamometer and provides digital readouts on the front panel. The features that makethe DSP7000 unique include:• Two Channels - Enables unit to support a combination of up to two testing instruments withindependent or tandem configurations.• Built-In Alarm System - To caution the user when problems occur, there are automaticelectrical and temperature alarms programmed into the unit. Also inherent to the unit areoptional power, speed, torque, air flow, water flow and external input alarms that becomeactive when enabled by the user.• Torque/Speed Analog Outputs - Able to interface with a data acquisition system• Digital Filter - Removes undesired noise from torque signals.• Saving - Allows user to save programmed values within their configurations.1.1 unpaCking your dsp7000Your DSP7000 was packaged carefully for shipping. Please notify your carrier and Magtrol CustomerService if you believe your unit was damaged in shipping.1. Save all shipping cartons and packaging material until you inspect the DSP7000.2. Inspect the DSP7000 for any evidence of damage in shipping.3. Make sure the carton contains the following:DSP7000 Dynamometer ControllerLine cordMagtrol User Manual CD-RomUSb Cord
