19SETUP3. Installation/ConfigurationNote: before installing the DSP7000, you should become familiar withthe front and rear panels, as outlined in Chapter 2–Controls.3.1 powering up the dsp7000Warning! TO rEDUCE THE riSK OF ELECTriC SHOCK, MaKESUrE THE DSP7000 iS EarTH grOUnDED BEFOrESTarTing!3.1.1 Self-TeSTAfter turning the power on to the DSP7000, the display panel will show the message “SERIAL kEYPAD REV x.x” while the DSP7000 is downloading the program.POWERBRAKE STATUS SET POINT SET POINT P I DTORQUE SPEED USER DISPLAYSERIAL KEY PAD REV X.XFigure 3–1 Program Download DisplayWhen the program download is complete, the message “MAgTRoL MoDEL DSP700x, FWREV:xx, FPgA REV:xx” appears.POWERBRAKE STATUS SET POINT SET POINT P I DTORQUE SPEED USER DISPLAYMAGTROLMODEL DSP700XFW REV:XX FPGA REV:XXFigure 3–2 Revision DisplayIf the alarms are disabled, the following display message will appear at this time.POWERBRAKE STATUS SET POINT SET POINT P I DTORQUE SPEED USER DISPLAYWARNING ALL ALARMS ARE DISABLEDON TSCXFigure 3-3 Alarm Warning DisplayTo activate the alarms, refer to Chapter 6 - Alarm System.
