21Magtrol Model DSP7000 Dynamometer Controller C h a p t e r 3 – Installation/Con gurationSETUP3.2.1 D ynaMoMeTer ConfiguraTion MenuTo reach the dynamometer configuration menu:1. Turn on DSP7000 power. See Section 3.1 – Powering Up the DSP7000.2. Press ShIFT. The word “ShIFT” will appear in the display.3. Press the SETUP button. The display should appear as follows:POWERBRAKE STATUS SET POINT SET POINT P I DTORQUE SPEED USER DISPLAYDYNO I/O SYSTEM USER Figure 3–5 Setup Menu4. Select DYNo. The display should appear as follows:POWERBRAKE STATUS SET POINT SET POINT P I DTORQUE SPEED USER DISPLAYMAXPOWER DYNAMOMETER ENCODERS ALARMS Figure 3-6 Dyno Setup Menu5. Select DYNAMoMETER. The display should appear as follows:POWERBRAKE STATUS SET POINT SET POINT P I DTORQUE SPEED USER DISPLAYTSCXHDINPUT UNITS FILTERN.m NONEFigure 3–7 Dynamometer Configuration Menu6. Pressing the PoWER UNITS button allows selection of the preferred testing device (hD,Wb, Pb or hD5) for TSC1. Pressing the MAx SPEED button allows selection of the inputunits (N·m, oz·in, oz·ft, lb·in, lb·ft, g·cm, kg·cm, mN·m, cN·m). Pressing SCALE I allowsselection of a filter if desired. Refer to the remainder of this chapter for more detailedinstructions on setup and configuration of the different testing devices.NoTE: For information on Filters, see Section 3.3 – Torque Filter Setup.
