35Magtrol Model DSP7000 Dynamometer Controller C h a p t e r 3 – Installation/Con gurationSETUPPOWERBRAKE STATUS SET POINT SET POINT P I DTORQUE SPEED USER DISPLAYSOURCEXXXX PPRXXSPEED ALARMXXXXFigure 3–28 Encoder Menu5. Press PoWER UNITS button until the desired source selection for the TSC is reached (TAChA, qUAD DEg, AI 1).3.4.1 TaCH a1. From the main menu follow the instrumentation setup instructions. See Section 3.4 -Instrumentation Setup (Speed) and Figure 3–28 Encoder Menu.2. Press ToRqUE UNITS button and use and buttons and Decrease/Increase dial to setthe PPR.3. Press SCALE P button and use and buttons and Decrease/Increase dial to set the SpeedAlarm.4. Press ShIFT 3 times to complete the setup and return to the main menu.3.4.2 quaD Deg1. From the main menu follow the instrumentation setup instructions. See Section 3.4 -Instrumentation Setup (Speed). The display should appear as follows:POWERBRAKE STATUS SET POINT SET POINT P I DTORQUE SPEED USER DISPLAYSOURCEQUAD DEG PPRXXSPEED ALARMXXXXANGLEXXFigure 3–29 QUAD DEG Menu2. Press ToRqUE UNITS button and use and buttons and Decrease/Increase dial to setthe PPR.3. Press MAx SPEED button and use and buttons and Decrease/Increase dial to set theAngles.4. Press SCALE P button and use and buttons and Decrease/Increase dial to set the SpeedAlarm.5. Press ShIFT 3 times to complete the setup and return to the main menu.3.4.3 ai 11. From the main menu follow the instrumentation setup instructions. See Section 3.4 -Instrumentation Setup (Speed). The display should appear as follows:
