32Magtrol Model DSP7000 Dynamometer ControllerChapter3 – Installation/Con gurationSETUP14. Select TANDEM. The display will appear as shown in Figure 3-22 Tandem ConfigurationMenu.14. Press the SCALE I button until the menu says “YES”.15. Press ShIFT once to reach the Maximum Speed Excited Menu as shown below.POWERBRAKE STATUS SET POINT SET POINT P I DTORQUE SPEED USER DISPLAYMAXIMUM SPEED EXCITED OF PB(CLUTCH DEACTIVATION) XXXXXFigure 3–24 Maximum Speed Excited Menu16. Press the SCALE P button and use and buttons and Decrease/Increase dial to setmaximum speed excited of Pb.17. Press ShIFT 3 times to complete initial setup and return to the main menu.Note: The TSC key is disabled in tandem configuration.3.2.10 in-line Torque TranSDuCer wiTH Brake3.2.10.1 Hardware ConnectionTorque Transducer(TM)DES Power SupplyHysteresisBrake(<1 Amp)Hysteresis Brake(<5 Amp)/Eddy-Current/Powder BrakeOR DSP 7001DYNAMOMETERCONTROLLERUSBM-TESTPCFigure 3-25 In-Line Torque Transducer with Brake3.2.10.2 Software Configuration1. Turn on the DSP7000 and proceed to the dynamometer configuration menu. See Section3.2.1 – Dynamometer Configuration Menu.2. Press PoWER UNITS until TM/TF is reached.3. Press ToRqUE UNITS until the desired brake is selected.4. Press MAx SPEED button and use and buttons and Decrease/Increase dial to set theScale Factor.
