64OPERATION7. Computer Controlled OperationThe DSP7000 can be used with a computer to control a dynamometer and to transmit data from themotor testing device directly to the computer. Using the DSP7000 with a computer enables the unitto perform at its full capacity.7.1 about the usb interfaCeThe USb interface is standard on the DSP7000. There is no need to set up. The USb interface willbe converted to a serial port in the PC. The USb driver must be installed in order for the DSP7000to communicate with the PC.7.1.1 uSB D river SeTup for winDowS operaTion SySTeMCopy the dsp7000Vx.inf or dsp7000Vx.xp.inf from the Magtrol website at www.magtrol.com/support/downloads.html into local drive of your PC.NoTE: If your PC is 64 bit operation system, then you need dsp7000Vx.inf to setup USb driver. If your PC is 32 bit operation system, thenyou need dsp7000Vx.xp.inf to setup USb driver.1. 1. Power on the DSP7000. A window in the right corner will show “Installing device driversoftware”.2. Click on the balloon depicted below will show which drivers did not install successfully.
