74Magtrol Model DSP7000 Dynamometer ControllerChapter7 – Computer ControlledOperationOPERATION7.3.2 TiMeouTSet the timeout for at least one second if asked to set a communication fault delay timeout.Note: If the communication fault delay timeout is too short, or if thecomputer resets the interface too quickly, the host instrument maystop responding.7.4 dsp7000 Command setWhen entering a command code:1. Type all characters in uppercase ASCII format.2. End all commands with a CR-LF (hex 0D-0A).3. Do not string multiple commands together in one line.The character # represents a floating-point numerical value following the command. Leading zeroesare not required.Note: If a command is not recognized, the I/o ERRoR message willappear in the Status Display accompanied by a beep.
