22Magtrol Model DSP7000 Dynamometer ControllerChapter3 – Installation/Con gurationSETUP3.2.2 H ySTereSiS DynaMoMeTer SeTup3.2.2.1 Hardware ConnectionAC MainsMotorUnderTestHysteresis Dynamometer (HD)DSP7001DYNAMOMETERCONTROLLERUSBPCM-TESTNo ConnectionFigure 3–8 Hysteresis Dynamometer Setup3.2.2.2 Software Configuration1. Turn on the DSP7000 and proceed to the dynamometer configuration menu. See Section3.2.1 – Dynamometer Configuration Menu.2. Press PoWER UNITS until hD is reached.3. Press MAx SPEED until the desired input unit for TSC.4. Press SCALE I to add a filter if desired.5. Press ShIFT. The display should appear as follows:POWERBRAKE STATUS SET POINT SET POINT P I DTORQUE SPEED USER DISPLAYTSC1 MAX TORQUEXXXXFigure 3–9 Hysteresis Setup Menu6. Press ToRqUE UNITS button and use and buttons and Decrease/Increase dial to setdesired max torque for TSC1.7. Press ShIFT 3 times to complete the initial setup and return to the main menu.
