iiidate edition Change section(s)03/09/13 2 nd Edition Din1,#, Din2,# command updated.TAC1,#, TAC2,# command updated.7.4.403/09/13 2 nd Edition Drawing updated 3.2.4.1, 3.2.5.1,3.2.7.1, 3.2.8.1,3.2.9.1, 3.2.10.103/09/13 2 nd Edition Note updated with correct section number for the TorqueFilter information.3.2.103/09/13 2 nd Edition New features updated. 1.202/20/13 1st Edition - rev. Q One “x” added to the OD1, OD2 command to show areturn of 6 speed digits.7.4.202/13/13 1st Edition - rev. P Section 6.8 How to Set the TM/TF Invert Flag added.DINØ, DIN1 changed to DIRØ, DIR1 in the note section.6.87.501/31/13 1st Edition - rev. O Step added to the setup instructions. 4.3.101/25/13 1st Edition - rev. N TMV1,# and TMV2,# command added.A note was added to the DSP6001 Mode instructions.7.4.77.501/04/13 1st Edition - rev. M F1,xx.xx and F2,xx.xx command function and definitionupdated.7.4.511/14/12 1st Edition - rev. L OS,# miscellaneous command added.Calibration of Frequency added to the calibrationprocedures.7.4.79.3.410/26/12 1st Edition - rev. K The Supply 1/Supply 2 pin descriptions updated. 2.4.105/29/12 1st Edition - rev. J Power Supply connector description changed to includeHD 825 dynamometers.1.304/25/12 1st Edition - rev. I Brake fuse changed to 1.25 Amps.Configure Output Binary table descriptions updated.1.37.2.203/14/12 1st Edition - rev. H OV,# command updated for both channels. 7.4.701/12/12 1st Edition - rev. G Section 6.6 How to Set Preload Control and section 6.7How to Set and Reset Tare Function was added.The ALC,# Alarm Command was added to section 7.4.1.The TS1, TS2, TR1 and TR2 Commands were added tosection 7.4.7.6.6, 6.77.4.1, 7.4.701/09/12 1st Edition - rev. F Driver and Tera Term location changed to Magtrol ManualCD7.1.1, 7.1.2, 8.4.212/27/11 1st Edition - rev. E USB Driver setup updated. 7.1.1, 7.1.212/13/11 1st Edition - rev D “Open or 8 Volts” was changed to “Open collector” for pin9 in section 8.1.2. Function was changed for ALR1,# andALR2,# in section 7.4.1.8.1.2, 7.4.112/06/11 1st Edition - rev C RPM vs PPR Chart added 3.412/02/11/ 1st Edition - rev B STAT command was updated in section 7.4.7 to includeramp down, ramp up, and mode input. The OP commandwas added in section 7.4.8.7.4.7, 7.4.811/14/11 1st Edition - rev A Contact Rating changed from 1 amp, 24 VDC to 24 VDC,1 amp max.5.1.1, 8.1.2
