27Magtrol Model DSP7000 Dynamometer Controller C h a p t e r 3 – Installation/Con gurationSETUP3.2.6 eDDy-CurrenT or powDer Brake DynaMoMeTer wiTH Torque T ranSDuCer SeTup3.2.6.1 Hardware ConnectionTM TorqueTransducerUSBPCM-TESTDSP 7002 Dynamometer ControllerExcitationTorqueTSC 401Torque-SpeedConditionerDES Power SupplySpeedEddy-Current (WB)OR Powder Brake (PB)DynamometerFigure 3–18 Eddy-Current or Powder Brake Dynamometer with Torque Transducer Setup3.2.6.2 Software Configuration1. Turn on the DSP7000. Set up TSC1 as described in section 3.2.5 Eddy-Current or PowderBrake Dynamometer Setup. Press TSC to swtich to TSC2 setup and proceed to thedynamometer configuration menu. See Section 3.2.1 – Dynamometer Configuration Menu.2. Press PoWER UNITS until TM/TF is reached.3. Press ToRqUE UNITS until Wb or Pb is reached.4. Press MAx SPEED button and use and buttons and Decrease/Increase dial to setdesired scale factor.5. Press SCALE I to add a filter if desired.6. Press ShIFT. The display should appear as follows:POWERBRAKE STATUS SET POINT SET POINT P I DTORQUE SPEED USER DISPLAYTSC2 MAX TORQUE NOMINAL SPEEDX.XXX XXXX.XFigure 3-19 TSC2 torque transducer setup menuPress the ToRqUE UNITS button and use and buttons and Decrease/Increase dial toset desired max torque. Press the SCALE P button and use and buttons and Decrease/Increase dial to set desired nominal speed. Press ShIFT 3 times to complete the initial setupand return to the main menu.
