11Magtrol Model DSP7000 Dynamometer Controller C h a p t e r 2 – ControlsGENERALINFORMATION2.2.1 Enabling SEcondary FunctionSTo enable the secondary function of the double-function control buttons:1. Press the blue ShIFT button and release it. The word “ShIFT” appears in the display:POWERBRAKE STATUS SET POINT SET POINT P I DTORQUE SPEED USER DISPLAY0.000 WOFF0.000 OZ.IN0000 0% 0% 0%0 SHIFTFigure 2–2 Secondary Function Menu2. Press any control button to enable the function shown in blue letters above the button.3. Press the ShIFT button again to exit the secondary function and return to main menu.Note: If the brake status is oN, the ShIFT button will be ignored.2.2.2 Enabling Saving FunctionTo save all current programmed settings:1. Press the ShIFT button two times. The word “SAVINg” will appear in the display, as shownin Figure 2–3 Saving Function Menu.POWERBRAKE STATUS SET POINT SET POINT P I DTORQUE SPEED USER DISPLAY0.000 WOFF0.000 OZ.IN0000 0% 0% 0%0 SAVINGFigure 2–3 Saving Function Menu2. After a few seconds, the menu will automatically return to the main menu display and allconfigurations of the unit will be saved into a non-volatile memory.
