– 111 –Chapter 5 Playback — Thumbnail operations14 Text memo indicatorDisplayed for clips with text memo data attached.15 Edit copied clip indicatorDisplayed for the edit copied clip.16 Wide clip indicatorDisplayed for clips recorded with the 16:9 aspect ratio. However, it does not accompany clips in HD format.17 Incomplete clip indicatorDisplayed when clips are saved across multiple P2 cards and either of the P2 cards is not inserted in a card slot.18 / Defective clip indicator, Unknown clip indicatorDisplayed for defective clips, which may result from various causes such as turning off the power during recording.Clips with yellow defective clip indicators can sometimes be restored.For details, refer to “Restoring clips” (page 115).Clips with red defective clip indicators cannot be restored and must be deleted. If the clip cannot be deleted, format the P2 card.is displayed for clips which differ in format from the P2 standard.19 Rec during upload status indicatorRec during upload status indicator shows the status of maximum 100 clips registered in the upload list as follows.(Gray) Displayed until upload starts.(Yellow) Displayed during upload.(Green) Displayed when upload is completed normally and registered in the upload list.(Red) Displayed when transfer error occurred during upload and registered in the upload list.20 [P.only] indicatorDisplayed for clips with proxy only.21 Thumbnail scroll barIndicates which part of the whole thumbnail is currently being viewed.22 Battery charge level indicatoris indicated when the camera is running on the battery, and is indicated when the camera is running on AC adaptor charging.Selecting thumbnailsMultiple thumbnails can be randomly selected on the thumbnail screen.Selecting clipsYou can select multiple clips randomly.1 Use the control stick to move the cursor over the desired clip.2 Press the control stick.A light blue frame and are displayed on the clip where the cursor is put. This indicates that it is selected.3 To select additional clips, repeat steps 1 to 2.It is possible to display only the selected clips on the thumbnail screen for playback.@@ NOTEt While holding down the button, press the control stick upward/downward to move the cursor to the first/last clip.t After selecting a clip, move the cursor to another clip and press the control stick while pressing the button to select all clips from thepreviously selected clip to the one at cursor position.t As clips are selected, the number of selected clips displayed on the lower right corner of the screen changes according to the selection.Deselecting clips1 Move the cursor to the selected clip and press the control stick.This deselects the clip.@@ NOTEt While holding down the button, press the button to deselect all the clips at once.
