– 144 –Chapter 6 Menu Operations — Menu listItem Description of settings[SDI OUT CHAR] Selects whether to superimpose characters on terminal output images.[ON]: Superimposes.[OFF]: Does not superimpose.f Factory setting: [OFF][SDI EDH] Selects whether to superimpose EDH when output from the terminal is SD signal (480i and576i).[ON]: Superimposes.[OFF]: Does not superimpose.f Factory setting: [ON][HD SDI REMOTE] Sets whether to use the control function of recording operation for an external device (such as a recorder)connected to the terminal at HD SDI output.[ON]: Controls the recording operation of the external device.[OFF]: Does not control the recording operation of the external device.f Factory setting: [OFF][DOWNCON MODE] Selects the mode of the down converter output signal mode from the or VIDEO OUT> terminal in HD mode (1080P, 1080i, or 720P).[SIDE CROP], [LETTER BOX], [SQUEEZE]f Factory setting: [LETTER BOX][DOWNCON SETTING] [DETAIL] Turns detail function for the down converter output signal [ON]/[OFF].[ON], [OFF]The down converter output signal contains detail components set during HD signal processing.This setting superimposes the detail components exclusive to down converter output to that signal.f Factory setting: [ON][H.DTL LEVEL] Sets horizontal detail correction level for the down converter output signal.[0]…[31]f Factory setting: [8][V.DTL LEVEL] Sets vertical detail correction level for the down converter output signal.[0]…[31]f Factory setting: [4][DTL CORING] Sets the detail noise removal level.[0]…[15]f Factory setting: [1][H.DTL FREQ] Selects the horizontal detail frequency.[2.5MHz], [3MHz], [3.5MHz], [4MHz], [4.5MHz]f Factory setting: [3.5MHz][VIDEO OUT] Selects the terminal output [ON]/[OFF].[ON]: Performs output.[OFF]: Stops output.f Factory setting: [OFF][VIDEO OUT CHAR] Selects whether to superimpose characters on terminal output images.[ON]: Superimposes.[OFF]: Does not superimpose.f Factory setting: [ON][VIDEO OUT ZEBRA] Selects whether the zebra pattern is superimposed over the output video signals from theVIDEO OUT> terminal.[ON]: Superimposes.[OFF]: Does not superimpose.f Factory setting: [OFF][TC OUT] Sets the type of time code output from the terminal.[TCG]: Outputs the time code generator value of the camera at all times.[TCG/TCR]: Outputs the time code generator value for camera image output, and the time code value ofthe video being played back for video playback output.f Factory setting: [TCG][TC OUTPUT REF] Sets the output delay of time code output from the terminal.[RECORDING]: Outputs the recorded time code with no delay. This is used when performing simultaneousrecording on two cameras with the time code of this camera as the master.[VIDEO OUT]: Matches to output images.f Factory setting: [VIDEO OUT][NETWORK SETUP]Configure the settings regarding the network.[4G/LTE PROPERTY] cannot be selected when the setting is not required on the connected 4G/LTE USB modem.Item Description of settings[USB MODE SELECT] Sets the camera operation mode when an external device is connected to the USB.[STORAGE]: Sets the mode to be used with connected devices such as an external hard disk drive.[DEVICE]: Selects the USB device mode for using P2 cards as mass storage, using computers or otherdevices connected via USB 2.0.f Factory setting: [STORAGE][USB MODE] Enables/disables the mode selected in [USB MODE SELECT].[ON], [OFF]f Factory setting: [OFF]
