–143–Chapter 6 Menu Operations—Menu listItemDescription of settings[RECORDING CHSETTING][FRONT VR SELECT]Sets the allocation to the dial. Enabled when the setting is other than .[0dB] to [−c] can be adjusted.[CH1], [CH2], [CH3], [CH4], [CH1/CH2], [CH3/CH4], [ALL], [OFF]fFactory setting: [OFF][AUTO LEVEL CH3]Selects the level setting method for audio channel 3.[ON]:Sets the mode to adjust automatically. The limiter does not work.[OFF]:The audio level follows the value for [LEVEL CONTROL CH3].fFactory setting: [ON][AUTO LEVEL CH4]Selects the level setting method for audio channel 4.[ON]:Sets the mode to adjust automatically. The limiter does not work.[OFF]:The audio level follows the value for [LEVEL CONTROL CH4].fFactory setting: [ON][LEVEL CONTROL CH3]Can be manually adjusted with this item when automatic level adjustment of audio channel 3 is [OFF].[0]…[100]fFactory setting: [70][LEVEL CONTROL CH4]Can be manually adjusted with this item when automatic level adjustment of audio channel 4 is [OFF].[0]…[100]fFactory setting: [70][MIC LOWCUT CH1]Enables/disables the lowcut filter for audio channel 1.[ON], [OFF]fFactory setting: [OFF][MIC LOWCUT CH2]Enables/disables the lowcut filter for audio channel 2.[ON], [OFF]fFactory setting: [OFF][MIC LOWCUT CH3]Enables/disables the lowcut filter for audio channel 3.[ON], [OFF]fFactory setting: [OFF][MIC LOWCUT CH4]Enables/disables the lowcut filter for audio channel 4.[ON], [OFF]fFactory setting: [OFF][LIMITER CH1]Enables/disables the limiter for audio channel 1.[ON], [OFF]fFactory setting: [OFF][LIMITER CH2]Enables/disables the limiter for audio channel 2.[ON], [OFF]fFactory setting: [OFF][LIMITER CH3]Enables/disables the limiter for audio channel 3.[ON], [OFF]fFactory setting: [OFF][LIMITER CH4]Enables/disables the limiter for audio channel 4.[ON], [OFF]fFactory setting: [OFF][HEADROOM]Sets the headroom (standard level).[12dB], [18dB], [20dB][OUTPUT SETTING][AUDIO OUT]Sets the audio signal output from the and built-in speaker.[CH1/2], [CH1], [CH2], [CH3/4], [CH3], [CH4]fFactory setting: [CH1/2][TEST TONE]Outputs rated level 1kHz tone signal according to the reference level.The standard level varies depending on the setting of [HEADROOM].[ON], [OFF]fFactory setting: [ON][OUTPUT SEL]Configure the settings regarding video output from , , , or terminal.ItemDescription of settings[SDI OUT]Selects video output from the terminal.[ON]:Outputs video.[OFF]:Does not output video.fFactory setting: [OFF][SDI&HDMI SELECT]Selects output signals from the terminal and terminal.[SYSTEM MODE]:Follows the setting in [SYSTEM MODE]→[LINE&FREQ].[1080i]:Converts into interlaced signals and outputs them when [1080-59.94P] or [1080-50P] is selectedin [SYSTEM MODE]→[LINE&FREQ]. This cannot be selected when other settings are made.[DOWNCON]:Down converts to SD signal and outputs.fFactory setting: [SYSTEM MODE][3G-SDI OUT]Selects 1080P signals of the HD SDI output in 1080P mode.[LEVEL-A]:Selects the LEVEL-A method.[LEVEL-B]:Selects the LEVEL-B DL method.fFactory setting: [LEVEL-B]
